Update¶
Python 3.10 users: install Python 3.11+ first
Tegvia requires Python 3.11 or newer (see Installation). Install it before updating. If only Python 3.10 is available, the launchers and the service installer print a message asking for Python 3.11+ and do nothing else (see Python too old).
Background service (default)¶
After updating the Tegvia folder (for example git pull), run restart so
the service loads the new version:
| System | Command |
|---|---|
| Linux, WSL, macOS | sh launch/tegvia-service.sh restart |
| Windows | launch\tegvia-service.cmd restart |
This is enough even when the dependencies changed: do not delete the .deps
folder. New Claude Code sessions go straight to the API for the few seconds of
the restart (see Restarts). You can then check
with status (same command, status instead of restart).
Standalone launcher¶
Stop the launcher (Ctrl-C, or close its window), update the folder, then start the launcher again. See Standalone deployment.
Archive¶
Follow the steps in Installation from an archive: uninstall the service from the old folder, extract the new archive, then install from the new folder.
If your version has expired (see Evaluation expiry), get a new archive from hello@tegvia.tech first.
Which version do the docs describe?¶
The footer of every documentation page shows the Tegvia version the documentation describes, so you can compare it with the version shown in the console. A documentation site built by hand, and the documentation built into the console, show no version.